Electronics enclosures

The enclosures are assembled from anodized aluminum profile, with a matte silver finish.

Enclosure height and width can be specified in 12.5 mm increments, excluding 62.5 mm. The minimum height and width are 25 mm. Enclosure depth can be selected as required. To prepare a layout, use the drawings profile.

The front panel is made from 1.5 mm anodized aluminum sheet. It can be machined for mounting components and marked with legends.
The front panel is fixed to the enclosure with self-tapping screws with countersunk, raised countersunk or pan heads.
An additional decorative plastic surround assembled from separate sections can be fitted over the front panel. The surround cannot subsequently be removed without damaging its sections, so installation and maintenance access is available only through the rear panel.

Special retainers are available for fitting a backplane and can be positioned at 25 mm intervals.
The retaining clips slide along the enclosure guides to the required depth.
The backplane is secured to the retainers with self-tapping screws.
Tightening the screws wedges the retainers into the housing guide grooves.

The rear of the enclosure can be closed with individual module panels or one common panel machined and marked for the installed components.

Text and graphics are applied to front panels using GEDACOLOR metal-printing technology. For details, visit GEDACOLOR-URAL).

Enclosure examples

AURA
AURA-KP
BIS-200
BIS-200
AURA-GPS
AURA-AK