The AURA-08-D recorder is designed for digital substations with an IEC 61850 process bus. It stores power-system disturbance waveforms on its own drive and subsequently transfers them to higher-level systems.
Request a quoteThe AURA-08-D digital fault recorder stores power-system disturbance waveforms on its own drive and subsequently transfers them to higher-level systems. The recorder forms part of the AURA-07 hardware and software systems.
AURA-08-D receives digitized instantaneous analog measurements and binary signal states. It processes these values mathematically, for example using a Fourier transform for analog signals and a debounce filter for binary signals, then compares the results against user-defined settings to detect the onset of a power-system disturbance. When a trigger condition is met, it records a COMTRADE disturbance file containing all recorded quantities over a configured interval before and after the trigger. The recorded files are made available for event analysis. The recorder also performs an initial automatic event analysis and provides its results to the user.
The recorder also provides related functions, including calculating and transmitting RMS measurements for diagnostics, SCADA and process control, and recording network traffic during a disturbance for subsequent analysis.
The recorder is built on a Vecow hardware platform; other hardware platforms can also be used.
digital substations with an IEC 61850 process bus.
Interoperability has been tested with devices from the following manufacturers.| Parameter | Value |
|---|---|
| Maximum trigger response time, ms | 10 |
| Pre-fault recording duration, s | 0…60 |
| Continuous disturbance recording duration, s | 0…3600+ |
| Post-fault recording duration, s | 0…3600+ |
| Sustained-trigger blocking | Yes |
| Automatic disabling and re-enabling of triggers that remain continuously active | Yes |
| Total duration of waveform records stored simultaneously in the recorder’s nonvolatile memory, per 100 GiB of allocated storage, h | Calculated using the formula below |
| - with 256 analog channels, 1,024 binary channels, 1,000 Hz sampling and BINARY format | 40 |
| – with 256 analog channels, 4096 binary channels, 2400 Hz sampling and FLOAT32 format | 10 |
Enabling network traffic recording consumes additional disk space in proportion to the actual volume of recorded traffic, which may reduce the total duration of waveform records that can be stored.
The recorder log can hold up to 40 MiB. It consists of text files: up to nine completed 4 MiB files and one current file of up to 4 MiB. The log is accessible through the web interface and is copied automatically to a connected USB flash drive. When the log reaches its capacity, the oldest file is deleted.
Some specifications may vary with the hardware platform used.
The recorder can also capture network traffic while recording a waveform. Captured traffic is saved in a *.pcap file and can be viewed and analyzed using suitable software, such as Wireshark.
The recorder software provides the following functions specified in STO 34.01-4.1-002-2017: